SAS-99 on 2003 BD Chopper
- Thread starter raeggis
- Start date
I don't think anyone has done this as everyone said it didn't fit.
Pin Bolt on the transmission? Not sure I know what you are talking about never seen a Pin Bolt on a BigDog other than the Brake Caliper
Last edited:
Picture please.
It's just a hex bolt, yes? I'm not sure what you would replace it with that would be more low profile?
Sent from my 2PS64 using Tapatalk
raeggis
Member
I want low profile om that bolt, so i Will try to use Hexagon Socket Countersunk Screw.
Except the hole isn't counterbored to accept this kind of bolt. You won't get much of a bite.
How many do you need to swap out? To get it to fit?
Sent from my 2PS64 using Tapatalk
raeggis
Member
Is there anyone who can describe the problem. Will cylinders hit the gear box plate?
Still not sure on what your doing. can you get a picture of where it goes.
This unit goes in place of the shocks.
I am nearly certain the tubes are much too big to fit regardless of bolts. We already run slim shocks on Big dogs and these air rides were made for Harley softails which can accept a larger Diameter shock.
I believe the diameter of the shock body is going to be too large that the shock eyelets won't bolt up.
I had an old thread on this unit and I think someone tried it and won't fit.
Sent from my 2PS64 using Tapatalk
Ok, I see.
Well that's neat I'm Curious what you had to do there
Sent from my 2PS64 using Tapatalk
raeggis
Member
What was needed was to remove nut and bolt number 5 on the right side under transmission mount plate (see picture number 2) . New lining must be rotated in metal pulley.
Last edited:
We're you able to replace the bolt or just now only have 5 bolts holding your transmission on?
Sent from my 2PS64 using Tapatalk
raeggis
Member
I remowed this bolt