Well I had way too much crammed in that small BDM manual 3 ring. So I picked up a new slightly larger 3 D ring binder from the office shop. Put in the BDM manual , the S&S super G, S&S super sidewinder, and BDM troubleshooting flow chart. Designed a new cover, side cover and rear cover sheets. Turned out pretty good. Generic enough to pass around... well besides the side cover. So here's what they look like. Front Cover Side Cover Rear Cover Its what's on the inside that counts... BDM Manual Little tabs for quick greasy hands flipping Troubleshooting Diagnosis flow charts S&S Super G S&S Super Sidewinder Plus more room for expansion, but not so big that its hard to move around and keep on the shelf. But a nice change over the tight squeeze I had in the factory binder. Plus I have been and predict alot more use of it with the current project. I have a PDF file for the front and rear and can make about anything for anybody for the sides (just don't ask for cool artwork, but if you got it, I can use it), so just ask and I'll shoot them over to you.