Blinker replace 2010 k9

BUCK NAKED

BUCK NAKED

Member
replacing my front led that is burned out and I see the old one had a big gob of some kind of glue holding to the metal housing what is it and what has every one been using to put it back together
 
BWG56

BWG56

Guru
After you pull the lens off, the pc board with the lights in it has a rubber gasket around it and all you do is pull it out and unplug the board and replace it. Put the rubber gasket around the new led and push it back in the housing.
 
BUCK NAKED

BUCK NAKED

Member
A rubber boot goes around the metal housing and holds the circuit board but the is some kind of glue that covers the back of the board it took a heat gun to heat the glue enough to pry it a part
 

Attachments

Mr. Wright

Mr. Wright

Knows some things
The glue was to hold the heat sink on. Most of them didn't come with that, and really doesn't need to be put back on. But if you just have to, a hot glue gun will work
 
Th3InfamousI

Th3InfamousI

Administrator
Staff member
Mr. Wright said:
The glue was to hold the heat sink on. Most of them didn't come with that, and really doesn't need to be put back on. But if you just have to, a hot glue gun will work
Click to expand...
You seen one of those heat sinks before?

I was wondering what the hell it was? Looked plastic.

However I think what is most important is seeing what you got going on your avatar. Can't see its blurry

Sent from my 2PS64 using Tapatalk
 
Mr. Wright

Mr. Wright

Knows some things
Th3InfamousI said:
You seen one of those heat sinks before?

I was wondering what the hell it was? Looked plastic.

However I think what is most important is seeing what you got going on your avatar. Can't see its blurry

Sent from my 2PS64 using Tapatalk
Click to expand...
I started see the heat sink on the 09's. Why? I don't know, it not like their getting hot. Haven't seen any of the replacement ones with it on there.
 
You must log in or register to reply here.
Top