Outer Primary Torque Sequence

[TwistedOne]

Looking for the torque sequence for the outer priamry. I have an 05" Ridgeback and I see on other threads that the tightening sequence is important and i don't want to do this more then once. Does anyone have this. I' guess i need to order a manual for my Dog!!! Any sugestions??

:flag:

 

[BadBrad]

Looking for the torque sequence for the outer priamry. I have an 05" Ridgeback and I see on other threads that the tightening sequence is important and i don't want to do this more then once. Does anyone have this. I' guess i need to order a manual for my Dog!!! Any sugestions??

:flag:

try this!
Damn, that's small. Look in the gallery under my name. I think you can see a larger version.
http://www.bigdogbiker.com/photo/showphoto.php?photo=804&title=primary-torque-sequenc&cat=500

 

[Moespeeds]

It's 10 ft/lbs and I just criss cross them, doing the bottom center, top center, and front/rear, then criss cross the rest. Use an inch pound wrench or risk snapping bolts. Make sure you clean the mating surfaces and the groove for the gasket and the gasket itself. A little grease will hold it in place while you fit them up. A lot of covers leak a tiny bit when hot, but on really stubborn ones I just use a little RTV along the bottom when I seal them up.

 

[TwistedOne]

Thanks Guy's, that is what i was looking for. I'll let you know how it turns out. Not big on leaks so hopefully it will not leak at all.