Latest activity
-
Coolbreezin replied to the thread Speedo options.Excellent info. Thank you sir. -
I run an AutoMeter with GPS controller for speed. https://www.autometer.com/2-5-8-speedometer-0-120-mph-white-pro-cycle.html Looks like...
-
Rottweiler replied to the thread S&S 111 Polished / Diamond Cut Cylinders.Sorry about that. -
Rottweiler reacted to BakieBake's post in the thread S&S 111 Polished / Diamond Cut Cylinders with
Like.
I didn't win the semi final round. Finished in 5th -
Rottweiler reacted to knothead's post in the thread 03 Chopper clutch cable, eazy pull ramp. with Like.
Well heat isnt the issue now that I see a picture
-
Rottweiler reacted to DynoDave's post in the thread 03 Chopper clutch cable, eazy pull ramp. with Like.
Note; The length is the housing length.
-
Rottweiler reacted to Chong's post in the thread 03 Chopper clutch cable, eazy pull ramp. with Like.
I'll check today or tomorrow. Probably have to remove it to get a good measurement. Thanks
-
Rottweiler reacted to DynoDave's post in the thread 03 Chopper clutch cable, eazy pull ramp. with Like.
What's the length of your clutch cable? I have a new Magnum Sterling Chromite II clutch cable that's 63 11/16" long. Paid $130, will...
-
Alright cool, thanks.
-
DynoDave replied to the thread 03 Chopper clutch cable, eazy pull ramp..Note; The length is the housing length. -
I'll check today or tomorrow. Probably have to remove it to get a good measurement. Thanks
-
DynoDave replied to the thread 03 Chopper clutch cable, eazy pull ramp..What's the length of your clutch cable? I have a new Magnum Sterling Chromite II clutch cable that's 63 11/16" long. Paid $130, will...
-
-
Use a 40 amp fuse from the red block that you have in the picture going to the battery...then put the power wire on the ehc from the...
-
I do got a question about my circuit breaker and my new RIP Gen 2 kit I just put in. I had read about the warranty fix for the VR...
-
Finally got my squish tube out, ball bearings were lodged in between it and the inner wall of the hub..took some beating to get it...
