A few days ago the throttle cable housing came out of the switch housing, it still worked but was hanging down. I noticed that there is a brass bushing on the end of the polished 90 degree bent part of the housing, which had a very small grove in it for a clip that must of fell off. I pulled the switch housing apart and spent a lot of time tring to get a "E" clip to fit over the grove but even with using a small burr wasnt succesfull. THan as i turn the housing over a real small semicircle of wire fell out, which I assumed was what help it in. Put it back on and shoved the cable sheath back into the switch housing and it holdin so far. I like to know if either there is some better way to hold it in or if not where size that tiny wire clip is and where i could buy an extra.
THANKS
Nick
THANKS
Nick
