Need help please

[snaggy]

Hey guys
I'm wiring up a chopper and I'm using a wire plus 193 harness
STARTER RELAY
I have the main harness leads all good
I have red lead which goes to main breaker all good
I have green lead which goes to starter solenoid all good
On the instruction sheet there is a black ground lead coming off the green wire to the starter solenoid
Do I need to splice a ground wire on to green solenoid wire .
Or am I missing something here

 

[Rottweiler]

No
The green wire is the hot wire that picks up the solenoid.

 

[Rottweiler]

Look at the dia. again. The black wire from the starter relay goes to chassis ground.

 

[snaggy]

No
The green wire is the hot wire that picks up the solenoid.

Thanks for the reply rottweiler.
So if you look at the pics ..I don't have a black ground wire coming from relay...the only black lead I have is in the main harness.

 

[snaggy]

Maybe that diagram is telling me to ground the relay it self???

 

[Rottweiler]

How many wires come off the starter relay?

 

[Rottweiler]

You would think 4 two to pick it up, ground and signal them a hot and output to the solenoid.

 

[snaggy]

There is a red ...goes to breaker
There is a green ....goes to solenoid
8 wires in main harness
No black wire to ground

 

[Jersey Big Mike]

Ok, that's a bad drawing from them.

I'd plug that connector in and attach the red wire to the battery and use a volt meter to watch for power on the green wire. If you get power in the green wire ONLY when you press start, wire it up to the starter solenoid.
I think the ground the relay needs is in the connector (looks like duestch connector)
Very badly written and drawn notes.

 

[snaggy]

Thanks for reply big Mike..
I have connected red to breaker and green to solenoid spade pin..and grounded the module but I haven't tested anything yet....