gas tank
- Thread starter edward
- Start date
Rottweiler
Well-Known Member
Fuel Tank Liner Removal
Does anyone know of a best practice to achieve removing the liner inside my tanks? I'm wondering if it is possible to completely remove it. I recently removed the tanks to have them repainted and since they have sat without any fuel and been through a paint bake cycle, the liner is flaking off...
www.bigdogbiker.com
Mr. Wright
Knows some things
Remember, anything strong enough to remove the liner, will remove the paint on the out side. Luckily, all the ones I've done, were going to be painted afterwards. Do a search on here, there is a thread that mentions the name of a company that does it professedly
DynoDave
Guru
When I did mine I covered it with stretch film;
https://www.amazon.com/Wrapping-Dis...cphy=9030230&hvtargid=pla-2281435177658&psc=1
Use rubber caps with hose clamps for the fuel line fittings.
Use pipe cleaners to plug the fuel line tubes and vent tube before pouring in the new liner.
I was careful and didn't have any paint issues.
https://www.amazon.com/Wrapping-Dis...cphy=9030230&hvtargid=pla-2281435177658&psc=1
Use rubber caps with hose clamps for the fuel line fittings.
Use pipe cleaners to plug the fuel line tubes and vent tube before pouring in the new liner.
I was careful and didn't have any paint issues.
Look at plumbing stuff. I know they make rubber plugs for different size pipes that expand to stop water under pressure so I’m sure it would work for that. Should be something along those lines that will work
HMAN
I just like my Freedom
Shot in the dark but try a craft store. Hobby Lobby type places. They may have some larger sized rubber/cork plugs? Or shove a rag in the hole and tape the heck outta the fill hole? Id have the entire tank taped if I wasnt gonna repaint.
Chong
U-238
I had one i taped off and then painted over that with liquid mask .. Filled tank with acetone. Well some seeped out of pitcock and the paper masking tape wicked it up... Damaged some paint on lower edge of tank .
Bummer .. Further pain was acetone didn't touch the liner .. it set for two days
I'd send it out .. lot cheaper then new paint.
A couple well respected people on this forum suggested not trying what I did. And to just run it and flush as needed.. Poblem i was having was bad liner and a pin hole leak in one of the tank mount pockets. And the liner kit i purchased claimed it would bridge such issues and solve the leak. I had tried sealers, epoxy etc.
Here is a place that does it.
gastanklining.com
Bummer .. Further pain was acetone didn't touch the liner .. it set for two days
I'd send it out .. lot cheaper then new paint.
A couple well respected people on this forum suggested not trying what I did. And to just run it and flush as needed.. Poblem i was having was bad liner and a pin hole leak in one of the tank mount pockets. And the liner kit i purchased claimed it would bridge such issues and solve the leak. I had tried sealers, epoxy etc.
Here is a place that does it.
Fix Motorcycle Gas Tank, Rust Removal, Lining, Sealing, Fuel tank
Fix your motorcycle gas tank permanently. Gas tank rust removal, repair, cleaning, lining, sealing. America's #1 Gas tank repair and restoration service since 2002...
Last edited:
I had one i taped off and the painted over that with liquid mask .. Filled tank with acetone. Well some seeped out of pitcock and the paper masking tape wicked it up... Damaged some paint on lower edge of tank .
Bummer .. Further pain was acetone didn't touch the liner .. it set for two days
I'd send it out .. lot cheaper then new paint.
A couple well respected people on this forum suggested not trying what I did. And to just run it and flush as needed.. Only problem i was having was a pin hole leak in one of the tank mount pockets. And the liner kit i purchased claimed it would span such issues and solve the leak. I had tried sealers, epoxy etc.
Here is a place that does it.
Fix Motorcycle Gas Tank, Rust Removal, Lining, Sealing, Fuel tank
Fix your motorcycle gas tank permanently. Gas tank rust removal, repair, cleaning, lining, sealing. America's #1 Gas tank repair and restoration service since 2002...
john sachs
Well-Known Member
The several I have done, was to take the tank to a radiator repair shop. Most of them have the means to do anything to the tank, without hurting paint, etc. 