pressure release valve bubbles

[Ted Eiserman]

does anyone know how to replace the bubbles in my pressure release valves 05 big dog mastiff
117 s/s i removed the split tank and noticed the bubbles down in the release holes
were broken or should say dry cracked

 

[Ted Eiserman]

hey chubbs i noticed you responded to my question
but for the life of me i cant find your response

 

[HMAN]

You can find em @ JP cycles or like. Rubber caps. PIA to replace but doable.

S&S Cycle - 55-1009 - Compression Release Plastic Cover for Electric Compression Release Kit for sale online | eBay

Find many great new & used options and get the best deals for S&S Cycle - 55-1009 - Compression Release Plastic Cover for Electric Compression Release Kit at the best online prices at eBay! Free shipping for many products!

www.ebay.com

 

[Ted Eiserman]

hey i was wondering if anyone new which push rod goes in what hole on my 117 s/s
i just replaced both compression release valves and noticed 2 pushrods are longer than the other
2 shorter ones. didnt realize this until i laid them out.if anyone knows i really need help on this
got to get it right thank you

 

[Mickmorris]

hey i was wondering if anyone new which push rod goes in what hole on my 117 s/s
i just replaced both compression release valves and noticed 2 pushrods are longer than the other
2 shorter ones. didnt realize this until i laid them out.if anyone knows i really need help on this
got to get it right thank you

The longer pushrod is the exhaust/ shorter is the intake. Front cylinder is longer to the front of the cylinder shorter back opening/ vise versa on rear cylinder

 

[Ted Eiserman]

hey fellow bikers just replaced compression release valves both
putting all new rocker box gasket kit includes gasket plates
under both boxes. does anyone know if any gasket maker/sealer should be used also.
i noticed when i removed old plates it looked like some clear silicon very little was used.
just gotta get it right thanks

 

[Mickmorris]

hey fellow bikers just replaced compression release valves both
putting all new rocker box gasket kit includes gasket plates
under both boxes. does anyone know if any gasket maker/sealer should be used also.
i noticed when i removed old plates it looked like some clear silicon very little was used.
just gotta get it right thanks

You might consider contacting S&S directly to be certain. This may help.

 

[Mr. Wright]

Put a little KY lube on the inside and they slide on easier. Soon as they heat up, the KY will dry.

 

[Mickmorris]

 

[Ted Eiserman]

You might consider contacting S&S directly to be certain. This may help. View attachment 133039

awesome thank you so much for the info. greatly helpful
first time doing this just wanted to be sure thanks again