N8KAM
Well-Known Member
Nope. I put the Gauge on after i bought the bike and used an elbow to angel it away from the pipe.
Show your exhaust
- Thread starter Gas Man
- Start date
Salty Dawg
Member
Had these on since about 2003 but might be changing them out this year for the hooker 4 into 1 pipe.
N8KAM
Well-Known Member
There you go Gas... Salty Dawgs pipes have a similar uneven gap.. Just need to do some tweaking
Had these on since about 2003 but might be changing them out this year for the hooker 4 into 1 pipe.
Chopper Dave
SIICK!!!
lets blow that up a little.....there we go! nice scoot!:up:
Sweet looking ride! Looks good in white.
Salty Dawg
Member
newbie dog
Active Member
Nice ride...like the clean white lines :2thumbs:
N8KAM
Well-Known Member
I stand corrected..:up: Nice scoot.. Now excuse me while i go adjust my pipes ..... some more.....:angry:Here is a better view that shows the pipes are even.
SD,
Had these on since about 2003 but might be changing them out this year for the hooker 4 into 1 pipe.
I got the same scoot as you and had the Hookers 4 Bidden on my bike. They don't fit. Look up a thread of mine I had up a few months ago when I put them on. You could probably fab. some way to mount them or tap your frame, but its def. a project. The pipes are made to fit harleys and not 250 rear tire frames.
I will say that they do look great, sound great, and perform great.
Just didn't fit well.
Salty Dawg
Member
Thanks for the info I'll look up the thread. Might be a project for next fall
Hello, Oscar Maldonado I don't want to cause a panic but the ultra slashed pipes that you are going to install on your bike may cause the stud on the rear cylinder to break. They are free floating and the vibration from the engine could cause the stud to break.I have a short set of pipes on my chopper and the vibration caused a stud on the rear cylinder of mine to break. I replaced the stud and made a short bracket running from the bolt that holds the pipes together to the transmission. No problems now... hope this info. will help
Salty Dawg
Member
Gas those pipes are sick!! Have you started it up yet?
No but when I do... I will get a video of it starting... and post it... OF COARSE!!!
BIGVICK35
Member
Hey sul let me know what is the RB pipe your talking about?i have the 4-biddens and tapped the frame right thru the c-cut. they still should sit in about another 1/4". i might try to collapse the back of the pipe to make it up. they sound decent but seem to be a real good performance pipe. if you can get a used set it'd be worth messing with. if your gonna pay retail then get the RB pipe. IMO
